Adjust Etac Prio for Leaning Posture

Assess the pelvis and thigh position carefully and evaluate if the user can tolerate corrections.

Seat: The thigh position is important for stability and upper body balance. Use an adjustable seat cushion or create a shape with additional cell foam wedges (1,2) that can be attached under the cushion cover directly to the foam. A pelvic obliquity can be accommodated for with the Large Cell Foam Wedge (3). Back Support: The 3D Back Support (4) contours perfectly to the users back and the tension adjustable back straps stabilize and support the trunk. Trunk Support: The trunk may need lateral support (5). They should be positioned higher on the side the person is leaning to and counteract further down on the opposite side. Positioning Belt: Use a positioning belt (6) if the user has sliding problems. Arm Support: If the user is leaning towards the arm support, make sure the height is appropriate and choose the arm supports with a wide and soft plate, maybe with a soft cover (7). In some cases, the arm supports may be set with different heights. Tray (8): A support from the front, can help the user to better trunk symmetry.

Tilt and Recline Positions: Both the active and resting position need to be carefully assessed. A too upright position may trigger lateral flexion. Secure the active seat tilt with the Comfort Tilt Lock (9) and the active back support position with the Back Angle Control (10). Anti-tippers: Always check the adjustment.

1, 2. Wedges, Cell Foam
With the wedges, support for the thigh can be created on a non contoured seat cushion. The cell foam wedges can be attached under the cover with the included self adhesive Velcro.

3. Wedge, Model 3 (large)
Attach the wedge under the cover to the cushion´s underside on the user´s low side.

4. 3D Back Support System
Three vertically placed soft cushions with plush cover, connected with sliding fabric and extra long tension adjustable back straps. It conforms perfectly to a curved back. Height adjustable between 45- 60 cm (18"- 23½").

5. Lateral Support
Choose between "swing away" and "adjustable" model. Both are adjustable in height, depth
and width. The pad is softly curved with a soft end.

6. Positioning Belt
To provide a positioning support, the belt should be attach with not less than 70° angle to the seat frame

7. Arm Support Soft Cover
The cover is padded and removable.

8. Tray
It attaches to the arm supports with Velcro straps.

9. Comfort Tilt Lock
Stops the tilt position at a preset angle. Choose between: 0°, 4°, 8° or 12° seat tilt. The position can be changed by moving the locking device on the gas piston.

10. Back Angle Control
By adjusting the length of the strap, the active back support setting can be controlled. The back will always stop at the preset angle. Note: The Back Angle Control will be available during 2019.