Adjust Etac Prio for Kyphosis

In a multi-functional wheelchair, the back is usually adjusted high, covering the shoulders. Make sure the user has full contact with the back support, from the level of PSIS and up, preferably over the top of the kyphosis.  

Back Support: The 3D Back Support (1) fulfills all these demands. It can be contoured both in the horizontal and vertical plane. The tension adjustable back straps (2) ensure an individual contoured shape and the soft vertical side cushions provide high comfort. Adjust the Dynamic Pelvic Support (3) in the level of PSIS with the user positioned in the active position. Wedges: The back can be supplemented with Cell Foam Wedges (4) for example if the sides need to be firmer.
Multi-Adjustable Head Support (5): It has the best settings to meet a kyphotic user´s head position. Arm Supports: Usually they need to be adjusted very low. The Narrow Arm Supports (6) can be set as low as 23 cm (9”). Tray (7): If the user has the tendency to flex forward, a tray could be a solution. The user can support the upper body with the forearms on the tray.

Tilt and Recline Positions: Combine all adjustment with carefully tried out tilt and recline settings and the chance for a better head position is considerably improved. Secure the active position with Comfort Tilt Lock (8) and Back Angle Control (9). The resting position is secured with Gas Piston Clips (10). Anti-tippers: Always check the adjustment.

1. 3D Back Support
Three vertically placed soft cushions with plush cover, connected with sliding fabric and extra long tension adjustable back straps. It conforms perfectly to a curved back. Height adjustable between 45- 60 cm (18"- 23½").

2. Tension Adjustable Back Straps
The long back straps ensure there will be enough rear space for the kyphosis

3. Dynamic Pelvic Support
Automatically relieves the tension in the reclined position and re-tightens in the active position. Adjust the height to the level of PSIS.

4. Wedges, Cell Foam
The back support can be further contoured with cell foam wedges. They attach under the back cover with self adhesive Velcro, included with the wedges.

5. Multi-Adjustable Head Support
With adjustability in height angle and depth to meet the user´s head position. The head support can also be adjusted sideways.

6. Arm Support, narrow
The arm plate is only 5 cm (2") wide which facilitates to reach the handrim. The narrow model can also be set as low as 23 cm ( 9").

7. Tray
To be attached to the arm supports with Velcro straps.

10. Gas piston clips
Each clip reduces the angling with approximately 2°. Can be used for both tilt and recline gas pistons. Easy to attach, easy to remove.

8. Comfort Tilt Lock
Stops the tilt position at a preset angle. Choose between: 0°, 4°, 8° or 12° seat tilt. The position
can be changed by moving the locking device on the gas piston.

9. Back angle control
By adjusting the length of the strap, the active back support setting can be controlled. The back will always stop at the preset angle.